SKU KCS-PATCH-2M

Network Patch Cord 2 m

KSh 300
In stock — pick up today in Nairobi CBD

A 2 m network patch cord is a ready-made lead with a plug at each end and enough length to reach across a desk or between racks a little apart. It suits connecting a computer, recorder or access point to a nearby wall socket or switch in Kenyan homes and offices.

  • Fixed 2 m length
  • Connector at each end, ready to plug in
  • Reaches from a wall point to a desk or shelf
  • Suits computers, recorders and routers
How our CCTV installation works, and what it costs ↗
  • Pickup from 3 Nairobi branches
  • Nairobi delivery from KSh 200 (KSh 50/km)
  • Countrywide courier in 1–3 working days
  • Pay by M-Pesa, cash or bank transfer

Overview

A 2 m patch cord is the middle length of our three patch cords. Two metres gives you enough reach to go from a wall socket to a computer, or from one rack to the next, without a lot of loose cable lying around.

What a 2 m lead suits

This is the everyday length for work stations. A network point in the wall is rarely right next to the computer, and a 2 m cord covers the gap to a desk, a recorder on a shelf, or a TV unit with a set-top box. In a comms room it also bridges between a patch panel and a switch that is mounted a few units away, or between two adjacent cabinets.

Key features

  • Fixed length of 2 m
  • Connector at each end, ready to plug in
  • Reaches from a wall point to nearby equipment
  • Gives some slack without much excess cable

Where to use it in Kenya

In a Nairobi office, 2 m cords connect staff computers and VoIP phones to wall points. In a shop, they link the CCTV recorder to a router or switch kept under the counter. At home they connect a smart TV or a games console to the router. They also suit the NVR in a small security room where equipment is spread along a shelf.

Installation and setup

Plug each end in until the clip clicks. Allow a gentle curve, not a sharp bend, near each connector. Run the cord along the edge of the desk or behind the unit and secure it with clips or ties so it cannot be snagged or pulled. Label the ends if several cords look alike.

What you need with it

  • Equipment and wall points with network ports
  • Clips, ties or trunking for a tidy route
  • A shorter 1 m cord for equipment close together, or 3 m for further apart

Choosing the length

Pick 2 m when the equipment is across a desk or a short stretch of wall from the socket. Leave excess cable coiled loosely rather than tightly wound.

Ask our team at the Kefa CCTV Shop on Moi Avenue, Nairobi for the exact specification of the cord in stock.

Frequently asked questions

What is a 2 m patch cord used for?

It is the usual length for connecting a computer, phone or recorder to a nearby wall point, or a switch to equipment a short distance away. It gives some slack without leaving a large amount of surplus cable to coil up.

Should I choose 2 m or 3 m?

Measure the route the cable will take, including the run up and down a wall or around a desk, then add a little slack. If 2 m is just enough, choose it. If the route is longer or you want to be safe, go for 3 m.

Can I join two patch cords together?

You can with a coupler, but every join adds a possible fault and weakens the link. It is better to use one cord of the right length. Ask our team at the Kefa CCTV Shop in Nairobi to help you pick the length.

KSh 300 In stock