RJ45 Connector Boots
RJ45 connector boots are small slip-on covers that fit over the end of an RJ45 network plug. They protect the plug and its latch where the cable meets the connector. Useful on patch leads and camera cables in homes, offices and shops across Kenya.
- Slip-on covers for RJ45 network plugs
- Protect the plug end and latch
- Neater finish on patch leads
- Fit over the cable before crimping
Frequently bought together
Complete your setup in one go- Pickup from 3 Nairobi branches
- Nairobi delivery from KSh 200 (KSh 50/km)
- Countrywide courier in 1–3 working days
- Pay by M-Pesa, cash or bank transfer
Overview
RJ45 connector boots are small flexible sleeves that slide over a network plug and the cable behind it. If you make your own patch leads or camera cables in Nairobi or elsewhere in Kenya, boots give the finished end a neater, more protected look.
What a boot does
- Covers the join between the cable and the plug, where the cable is most likely to bend and wear.
- Helps stop the plug latch from snagging on other cables when leads are pulled around.
- Gives a tidy finish, and where boots of different colours are available they let you tell leads apart.
Where to use them
Boots are most useful on patch leads that are plugged and unplugged often, such as those in a rack, behind a TV or on a desk. On IP camera cabling they finish the NVR or switch end neatly, where several leads sit close together.
They are not a substitute for a properly crimped plug. A boot protects a good termination but cannot fix a bad one, so crimp and test the lead first.
How to fit a boot
- Slide the boot onto the bare cable before you fit the plug. This is the step most people forget.
- Strip, arrange and crimp the RJ45 plug as normal, then test the lead.
- Slide the boot forward over the plug body until it sits snugly against the latch end.
If you have forgotten to fit the boot first, you will usually have to cut off the plug and crimp a new one.
What to buy with them
Boots go with RJ45 connectors, network cable, a crimping tool and a cable tester. Our team can help you match boots to the cable and plugs you are using.
Boot size depends on the cable thickness and plug type, so check that the boot you choose fits your cable. Ask our team at the Kefa CCTV Shop on Moi Avenue, Nairobi for the exact specification of the unit in stock.
Frequently asked questions
Do I fit the boot before or after crimping the plug?
Before. Slide the boot onto the bare cable first, with the narrow end facing the cable end, then strip and crimp the plug. The plug will not pass through the boot afterwards, so if you forget you normally have to cut the plug off and crimp a new one.
Do boots slow down or affect the network signal?
No. A boot is only a plastic or rubber-like cover over the outside of the plug and does not touch the wires. It protects the plug and cable end from knocks and bending. The quality of the crimp and the cable decides the network performance, so test every lead with a cable tester.
Will one boot size fit all RJ45 plugs and cables?
Not always. Boots are made around the plug body and the cable thickness. Thicker cables and some plug types need a larger opening. Bring a sample plug and cable to the Kefa CCTV Shop on Moi Avenue, Nairobi, or ask our team to check the fit before you buy.

