
6-Core Alarm Cable
6-core alarm cable carries six conductors in one jacket, giving room for power, alarm and tamper connections on a single run. It suits detectors, keypads and zone expanders in Kenyan alarm systems where 4-core is too tight.
- Six insulated cores in one outer jacket
- Carries power, alarm and tamper on one run
- Fewer cables to pull on busy installs
- Insulated cores for tidy termination
- Pickup from 3 Nairobi branches
- Nairobi delivery from KSh 200 (KSh 50/km)
- Countrywide courier in 1–3 working days
- Pay by M-Pesa, cash or bank transfer
Overview
6 core alarm cable has six insulated conductors inside one outer jacket. It sits between the basic 4-core cable and the larger 8-core, and it is chosen when a device needs more than power and a single alarm contact on the same run.
Why six cores
A modern detector often has separate connections for power, an alarm output and a tamper switch. That is already six wires. A keypad needs power plus data lines, which also adds up quickly. With six cores you can complete these connections in one cable instead of pulling two, and you may still have a spare core or two for later.
Key features
- Six conductors in one jacket
- Room for power, alarm and tamper circuits together
- One cable instead of two on busier device runs
- Individually insulated cores for tidy terminations
Where to use it in Kenya
Choose it for PIR motion detectors with tamper outputs, wired keypads, and the main cable between a panel and a zone expander in a house, office block or shop. It is a sensible default when you are cabling a new building and want to avoid pulling extra cable later.
Installation and setup
Plan the run from the panel to each device before you cut, and measure the route including corners, risers and the slack you want at each end. Keep alarm cable apart from mains cable, fix it with clips, and leave a service loop at the device so it can be re-terminated. Match each core to a terminal as shown in the device instructions and record which core goes where. Test zones, tamper and power at the panel before closing up trunking or plaster.
What you need with it
- Cable clips or trunking
- A control panel and the devices to be wired
- Terminal screwdrivers and a multimeter for testing
Ask our team at the Kefa CCTV Shop on Moi Avenue, Nairobi how this cable is sold, and for its exact specification. We deliver within Nairobi and send by courier across Kenya.
Frequently asked questions
What is the difference between 4-core and 6-core alarm cable?
Both are alarm cables, but 6-core carries two more conductors than 4-core. That extra capacity lets one run carry power, alarm and tamper connections together, or leave spare cores for later changes, where a 4-core cable would only cover power and one signal. Pick by what your devices need.
What devices need 6-core cable?
Devices with separate power, alarm and tamper connections, such as many motion detectors, and wired keypads or expanders that need data lines. Always check the instructions for the device for the number of wires it needs before you choose the cable.
Can I run alarm cable beside mains cable?
Avoid it where possible, because mains cable can cause interference on alarm signals. Keep the cables apart, and where they must cross, cross them at right angles. Use clips or separate trunking so each cable stays in its own route.