
PoE Extender 1-In 4-Out LS-JB0104-AT-30W
The LS-JB0104-AT-30W is a PoE extender with one PoE input and four PoE outputs, marked 30 W. It takes a single network cable from the PoE switch or NVR and fans it out to four IP cameras at a distant point, letting installers in Kenya cover a far corner of a site without running several long cables or mains power.
- One PoE input feeds four PoE outputs
- Marked 30 W in the model code
- One cable serves a group of distant cameras
- No mains socket needed on site
- Pickup from 3 Nairobi branches
- Nairobi delivery from KSh 200 (KSh 50/km)
- Countrywide courier in 1–3 working days
- Pay by M-Pesa, cash or bank transfer
Overview
The LS-JB0104-AT-30W is a 4 port poe extender, one in and four out. One network cable carrying power and data comes in, and four network ports go out, each able to feed an IP camera or other PoE device. It works like a small PoE switch that powers itself from the cable, so it can sit far from the building with no socket nearby.
The problem it solves
On a big plot, school or warehouse yard, there is often one area with several cameras that is a long way from the recorder: a car park, a loading bay, a far gate or a perimeter corner. Running four separate cables over that distance costs time and cable, and each run is still limited to about 100 metres. With this extender, one cable goes out to the area and four short cables go to the cameras.
- One PoE input, four PoE outputs.
- Marked 30 W in the model code.
- Powered from the incoming PoE cable.
- Starts a new 100-metre Ethernet segment.
Plan the power carefully
Four cameras share whatever power reaches the extender from the switch or NVR. That makes power the main limit, not the number of ports. Add up the PoE consumption of all four cameras at night, when their illumination is on, and allow for the extender itself. Check this against the 30 W marking and against the output of the switch port feeding it. Low-power fixed cameras are the natural fit; PTZ cameras or cameras with heaters are not. Ask our team at the Kefa CCTV Shop on Moi Avenue, Nairobi for the exact specification of the unit in stock, including its power budget.
Installation and setup
Install the extender indoors or in a weatherproof box at the camera area, with cable entries facing down. Connect the incoming cable from the PoE switch or NVR to the input, then each camera to an output. Use solid-conductor network cable and test each connector, because one poor crimp on the input cable takes all four cameras offline. Kefa Solutions technicians can install IP camera systems.
Collect in Nairobi CBD, or order delivery within Nairobi or by courier across Kenya.
Frequently asked questions
Can I connect four PoE cameras to this extender?
Yes, if their combined power fits within what the extender receives and can pass on. Four cameras share one incoming PoE feed, so add up their consumption with night illumination on, plus the extender itself, and compare it with the 30 W marking and the switch port output. Low-power fixed cameras suit it well.
What is the difference between the 1 in 2 out and the 1 in 4 out extender?
Both extend a PoE cable run and need no mains power. The 1 in 2 out version feeds two devices, while this one feeds up to four from the same single cable. With four cameras sharing the incoming power, power planning matters more on this model.
Do I still need a PoE switch?
Yes. The extender takes its power from the cable, so the other end must connect to a PoE switch, PoE NVR or PoE injector that can supply enough power for the extender and all the cameras attached to it. Without PoE on the incoming cable, the extender and cameras stay off.