
Access Control Power Supply 12V 5A
A 12 V DC, 5 A power supply for access control systems in Kenya, sold at our Nairobi shop. It powers electric locks, magnetic locks, card readers and controllers from the mains, and suits two or more doors or a heavier load.
- 12 V DC output, 5 A
- About 60 W rated output
- For locks, readers and controllers
- Suits two or more doors or a heavier load
- Pickup from 3 Nairobi branches
- Nairobi delivery from KSh 200 (KSh 50/km)
- Countrywide courier in 1–3 working days
- Pay by M-Pesa, cash or bank transfer
Overview
A 12v 5a access control power supply converts mains electricity into the steady 12 V DC that door locks, card readers and access controllers need. Access control equipment should not run from loose adaptors, because an electric lock draws more current than a reader or keypad, and an under-rated supply makes locks weak or controllers restart.
Key features
A 5 A supply gives more headroom than a 3 A unit. It suits systems with several locks, a multi-door controller, or a magnetic lock that draws more current alongside readers and exit buttons.
- Output stated as DC 12 V, 5 A.
- Rated for about 60 W (12 V multiplied by 5 A).
- Made for access control: locks, readers, exit buttons and controllers.
- Mains in, low-voltage DC out, so the lock side of the system stays low voltage.
How to choose the right rating
At 12 V and 5 A the supply is rated for about 60 W. Add up the current of every lock, reader, exit button and controller on the supply, and keep the total comfortably under 5 A.
The 3 A version is enough for a single door with one lock.
Do not run the supply at its limit all day. Electric locks, and especially magnetic locks, are on continuously, so leave spare capacity.
Installation and setup
Mount the supply in a dry place, ideally inside the controller cabinet or close to it, away from rain and dust. Switch off the mains, connect the live, neutral and earth to the input side, then connect the DC output to the controller and lock. Check polarity before you power on, because reversed wires can damage readers and controllers.
Use cable of a suitable thickness for the run to the lock. Long thin cables lose voltage and a lock may fail to hold. Where a fire alarm or emergency release is needed, wire it in the lock circuit as the system design requires. Kefa Solutions technicians can install access control in Nairobi and across Kenya if you prefer a complete installation.
What you need with it
Plan the rest of the door at the same time:
- An access controller or standalone keypad and reader.
- An electric lock, drop bolt or magnetic lock.
- An exit button and, where required, an emergency break glass release.
- Suitable low-voltage cable and a fused spur or isolator for the mains side.
Ask our team at the Kefa CCTV Shop on Moi Avenue, Nairobi for the exact specification of the unit in stock. You can collect from the Kefa CCTV Shop on Moi Avenue, Nairobi CBD, have it delivered within Nairobi (up to 45 km), or ordered by courier across Kenya in 1 to 3 working days.
Frequently asked questions
What does a 12V 5 A access control power supply run?
It runs the low-voltage parts of a door system: the electric lock or magnetic lock, the card reader or keypad, the controller and the exit button. Add up their current ratings and keep the total below 5 A with some spare capacity.
Can I power a CCTV camera from it?
It is sold for access control, and the CCTV equipment has its own requirements. Check the voltage and current of the camera first, and use a supply meant for it. Mixing lock and camera loads can cause interference, so separate supplies are usually safer.
Is 5 A enough for my door?
Add up the current drawn by every device on the supply. If the total is well under 5 A it is enough; if it is close, choose a larger rating. The 3 A version is enough for a single door with one lock.
Can Kefa Solutions install it for me?
Yes. Kefa Solutions technicians install access control in Nairobi and by arrangement elsewhere in Kenya. Contact the Kefa CCTV Shop on Moi Avenue for details. Our team at the Kefa CCTV Shop on Moi Avenue, Nairobi can advise on the right choice for your job, and on the unit currently in stock, before you buy.
